Definition:
Standard, mm By Alternate US Standard
Gravel ——————- 2 mm to 75 mm No. 10 to 3 in.
Sand ——————- 0.05 mm to 2 mm No. 270 to No. 10
Silt ——————- 0.005 mm to 0.05mm
Clay ——————- 0.001 mm to 0.005 mm
Colloids—————— less than 0.001 mm
Engineering Properties
Granular Soils:
- Good load-bearing qualities.
- Permeable, hence they drain readily.
- Comparatively incompressible when subjected to static loads.
- Not subject to changes in strength or volume due to variation in water content. However, loose granular materials will undergo a considerable reduction in volume if subjected to vibratory loads.
Fine-Grained Soils:
- Poor load-sustaining qualities.
- Highly impermeable.
- Compressible under sustained load.
- Subject to changes in volume and strength due to variation in water content.
Organic Soils:
Identification – Visual and Texture
- GravelRounded or water-worn pebbles. No cohesion or plasticity. Crunchy underfoot.
- SandGritty and lose grains. Individual grains are readily seen and felt. No plasticity or cohesion. If dry, a cast formed in the hand will fall apart; if moist, a cast will crumble when touched.
Two simple manual tests are used to detect the presence of fines in the sand. If a handful of dry sand is sifted through the fingers and allowed to fall on the ground, it is considered dirty if an appreciable amount of dust appears. A small quantity of wet or dry sand is placed in a test tube or bottle, water is added and the bottle is shaken vigorously. The sand particles will settle 76.2 mm (3 in) in about 10 seconds. Therefore, if after about half a minute the top 76.2 mm (3 in) of water does not appear substantially clear, the sand may be considered dirty.
- Silt has fine and barely visible grains. When in a dry pulverized condition, it feels soft and floury. Can hardly be made plastic. Exhibits little or no strength when air-dried. A dried cast is easily crushed in the hands.
In the wet state, organic silt can be rolled into thin threads, but if the threads are more than a few inches long, they will not support their own weight if held by one end.
When mixed with water to the consistency of a thick paste, the surface of inorganic silt will appear wet and shiny if a pat is shaken in the palm of the hand; if the pat is squeezed, the surface will dry up, appear dry, and eventually crack. Clay, if treated similarly will not change in appearance. - Clay can be made of plastic by adjusting its water content. Cohesive. Exhibits considerable strength when dried; difficult or impossible to crush in hands.
Clay can be molded and rolled into thin threads without breaking or crumbling within a moderate to a wide range in water content, and threads of considerable length will support their own weight when held by one end. - Organic Soilsgray to black color. Fibrous structure due to the presence of undecomposed plant matter. unhealthy sewage-sludge odor. Found as deposits in swamps and peat bogs.